Moving Cutting Head To The Up Position; Raising The Cutting Head - Super-Ego 189 Betriebsanleitung

5. MOVING CUTTING HEAD TO THE

5.1 RAISING THE CUTTING HEAD

For shipping purposes, the cutting head (A) has been
secured to the down position by means of a fastening
bolt (B) - (Fig. 2).
To move the cutting head to the up position, simply
remove the bolt (B), by pulling it out backwards (Fig. 3).
UP POSITION
A
B
Fig. 2
Fig. 3
Fig. 4 shows the cutting head in the raised position.
Elements of Fig. 2-4
A: Cutting head
B: Fixing pin
Fig. 4
36