Unpacking - Super-Ego 189 Betriebsanleitung

Open the box and check for shipping damage.
Immediately report any damage to your distributor and shipping agent.
Do not discard any shipping material until the band saw is assembled and running properly.
Compare the contents of the box with the following parts list to make sure all parts are intact.
The saw has been set at the factory to make an accurate cut.
Before starting it up verifiy its proper accuracy.
It is possible that during transport the adjustment may have been unset. Were this to occur, please contact the vendor
or read the section "Operating Controls and Adjustments".
B
I
E
G
A: Base
B: Upper handle
C: Lower handle
D: Arch
E: Adjustment screw
F: Bench lathe plate
G: Crank handle

4. UNPACKING

K
H
F
A
H: Guide block for the cutting blade
I: Tightening knob for the cutting
blade
J: Protector against shavings
(cutting end stop in portable
mode)
K: Actuators
L: Angle adjustment crank handle
M: Fixing pin
35
D
R
J
N
L
O
M
Fig. 1
P
S
Q
N: Rocking base
O: Bevel cut angle scale
P: On / Off switch
Q: Power cable
R: Cutting blade
S: Allen tool set (3 keys)
K
C