Technical Assistance - SEAL 54 Base Betriebsanleitung

Pressure too low.
Figure 20: Wrinkles due to low pressure.
•
Increase the roller pressure a little (5-10%).
Unwind tension too low.
Figure 21: Wrinkles due to low unwind tension.
•
Increase the unwind tension until the wrinkles (6) in the film on the roller disappear. The lines
(7) in the process result will disappear as well.
Roller alignment fault.
Figure 22: Wrinkles due to faulty roller alignment.
The wrinkles occur on one side only (left or right).
•
This is a machine adjustment error. Contact your dealer and ask for technical assistance.
6.4

Technical assistance

For technical assistance you can contact your dealer or the address on the copyright page in the
front of this manual.
Make a clear description of the problem before contacting technical assistance.
Please keep the type and serial number of your machine at hand.
You can find this data on the identification plate of your machine, which can be found on the rear
side of the right cabinet.
32 User Manual 54Base