Installation; Unpacking - SEAL 54 Base Betriebsanleitung

4 INSTALLATION

WARNING:
INSTALLATION MUST BE CARRIED OUT BY SKILLED PERSONNEL.
4.1

Unpacking

At delivery, the machine is packed in a plastic bag to avoid moisture penetration. It is transported in
a carton box and is fastened onto a wooden pallet.
Place the pallet in a space where there is enough room to roll the machine off from the pallet
(approx. 5.5 m).
To unpack, follow the steps below (refer to Figure 5);
1.
Cut the straps, lift off the carton box, remove the plastic bag and put the accessories aside.
Figure 5: Ramp positioning.
2.
Remove the four securing bolts (1).
3.
Turn down the four leveling feet (2) to lift the machine and remove the wooden blocks (3).
4.
Unscrew and remove the two ramps (4). Place the two ramps (4) against the roll-off side of the
pallet so that the castors (5) will run clear from the edge.
5.
Turn up the four leveling feet (2) completely to put the machine on its castors (5).
6.
Roll the machine off carefully from the pallet using the ramps.
WARNING:
ROLL THE MACHINE OFF WITH 2 PERSONS. IT IS HEAVY AND CAN NOT BE
CONTROLLED ALONE.
Note:
Save all packing material for later moving over long distances or discard of according to local
regulations.
14 User Manual 54Base