Replacement Of Milling Cutters; Solutions To Most Frequent Anomalies - Sima CAT 202 Gebrauchsanweisung

• Raise the platform of regulating motor nuts R, Fig.8 until the belt tension is just enough to avoid the
oscillation of the band.
• Place the receipt of the pulleys P, Fig.8 and secure with the screws T, Fig.8.
WARNING: When the transmission of the machine is synchronous toothed belt as they ride the
CAT model, no adjustment is needed because the excessive tension of the same teeth prevents slippage
and ensures a perfect transfer.

9. REPLACEMENT OF MILLING CUTTERS.

The change of strawberries drum is a normal operation, either because they are worn out, or because they are to
perform other work that requires a different strawberry. To replace proceed as follows:
• Loosen the screws T, Fig.9 and remove the flange side of the drum B, Fig.9. This flange has two threaded holes to
use as extractors with two screws removed from the flange. Tightening the two screws into the wall of the chassis of
the machine the flange will be separated from the machine.
• Remove the drum S, Fig.10 chassis manually sliding on his hexagonal axis.
• Remove the caps that the drum T, Fig.11 takes on both sides, loosening the screws to A, Fig.11 remove milling
cutter axes E, Fig.10 pushing for the end that has a recess.
•Placing milling cutters as we advance is being made pursuant to the axis from side to side, taking into account the
need to insert milling cutters F, Fig.11 and washer B, Fig.11.
WARNING: The milling cutters in one axis should not be faced with another. Should be placed alternately so
that each washer is in front of each milling cutter. If a shaft is positioned first in the washer, the following should be
placed a milling cutter first Fig.12
Note that milling cutters should be comfortably placed and move horizontally on its axis.
• Replace the two ends of the drum T, Fig.11 and enter it into the chassis by sliding it along its hexagonal axis.
• Tighten the flange side B, Fig.9.
Axles that support milling cutters should be replaced when significant wear is observed.

10. SOLUTIONS TO MOST FREQUENT ANOMALIES

ANOMALY
Petrol engine will not start
Electric engine will not start
Insufficient milling depth
Strong vibrations
POSIBLE CAUSA
Low oil level alarm is ON
Fuel cock closed
Motor switch is in OFF position
Machine emergency stop switch is
pressed
Nopower supply
Thermal protection is ON( single-
phase engine)
Switch is not working
appropriately
Drum is not rotating
appropriate
Depth of milling is not
Milling cutters too wear
Inappropriate milling cutter for the
type of work is being done
Some milling cutters are damage
appropriate
Depth of milling is not
11
SOLUTION
Top up as necessary
Open fuel cock
Turn switch to ON position
Release the button turning it upwards
Check mains
Cool down machine and rearm the
thermal protection
Change the switch
Change bearings or tensing
transmition
Regulate depth of milling
Change foe a new set of milling
cutters
Change to the appropriate milling
cutters
Change for a new set of milling
cutters
Regulate depth of milling
ENGLISH
belt