Machine Asembling; Electric And Petrol Engine; Petrol Engine; Single- Phase Electric Motor - Sima CAT 202 Gebrauchsanweisung

4.1 MACHINE ASEMBLING

It should proceed as follows:
- Unpack the top of the handlebar that is attached to the machine using a connecting piece for the transport
specified.
- Unpack the spindle of the machine and thread to the top of the handlebar.
- Mount the machine on top of the handlebar, as shown in Fig.3. Tighten the screws T, Fig.3 with the key
that is supplied.
- Screw the bottom of the spindle H, Fig.4 in their accommodation to A, Fig.4. You must enter the proper
screw length so you can achieve the spindle caught in the wheels of the machine B, Fig.4.
- Secure the bottom of the spindle to the fork and tighten the screw S, Fig 4 with the allen key that is
supplied.

5. ELECTRIC AND PETROL ENGINE.

5.1 PETROL ENGINE

Scarifier CAT 202 model is supplied with oil and without fuel in the engine
Must be read at all times the manual of the engine itself.
Fuel spillage on the machine to fill the tank and they can be dangerous or involve some element of it.
Before starting the engine check the oil level in the crankcase by placing the machine on a flat surface and
the engine stopped, if necessary, fill to complete the level with the type of oil recommended by the engine
manufacturer.

5.2 SINGLE- PHASE ELECTRIC MOTOR

These models are supplied with a 230V single phase electric motor with switch-plugs. The extension cord is
used must have a minimum area of 4x2, 5 mm2 to 25 meters in length. For a longer distance should use 4x4
mm2. At one end is placed the extender switch that includes the machine in endowment, and the other a plug
which is compatible with the output of the switchboard where you go to feed.
Scarifiers with single-phase electric motor leave factory always connected to work at 230 V.

5.3 THREE-PHASE ELECTRIC MOTOR WITH MACHINES.

These models are supplied with three-phase 230/400V electric motor with switch-plugs. The extension cord is
used must have a minimum area of 4x2, 5 mm2 to 25 meters in length. For longer distance should use 4x4
mm2. At one end is placed the extender or air base that includes the machine in endowment, and the other a
plug which is
The three-phase electric scarifier leaves factory connected to work at 400V. If necessary connect the machine
to a supply voltage of 230V, we change the position of the bridge chips in the motor terminal box, as shown
in the figure below:
compatible with the output of the switchboard
7
where you go to feed.
ENGLISH