Starting Up And Use Instructions; Quick Lifting Device; Handle Tube Adjustment; Regulation Of The Depth Of Milling - Sima CAT 202 Gebrauchsanweisung

Do not use the machine to the functions that it has been designed.
SIMA SA is not responsible for any consequences that may result in inappropriate use of the milling firm

6. STARTING UP AND USE INSTRUCTIONS

Warning: Follow all the mentioned safety recommendations and comply with the directives about labour
accidents and risks.
For further details, consult the engine manual.

6.1 QUICK LIFTING DEVICE

The scaifier CAT model has a lifting device and rapidly dropping the machine. It is used to move the machine without
losing the reference of milling depth.
This regulation is independent of adjustment of milling depth and is in the grip that is on the handlebar column at a
height easily accessible to the operator. E, Fig.5
To raise the machine
For the descent of the machine is moved slightly upward first handle to unlock the ratchet and then down until it
reaches its lower position.

6.2 HANDLE TUBE ADJUSTMENT

The handlebar of the scarifier incorporates a rectangular tube A, Fig.6 that height can be regulated as follows:
- Loosen the crank handle lock M, Fig.6
- Move the handle tube to find the most comfortable position for the user.
- To squeeze the handle to lock the handle in the position held.

6.3 REGULATION OF THE DEPTH OF MILLING.

The adjustment of the depth to which you want to perform a specified task is performed through the upper adjustment
wheel. Proceed as follows:
• With the engine stopped, place the drum in the working position by quickly lifting device. Fig.5
• Make sure that being in the position of work, the milling drum does not touch the ground. To do this you
need to unlock the nut that attaches the spindle P Fig.7.
• Turn the wheel counterclockwise to its maximum height, thus ensuring that the drum does not touch the
ground when the machine starts working.
• Start or connect the engine.
• Lower the milling drum by turning the depth adjustment wheel V, Fig.7 clockwise until the milling cutters
begin to touch the ground.
• Once you touch the ground with the milling cutters on the ground the machine is ready to get the desired
depth. Blocked by the spindle locknut P Fig.7 for the vibrations cannot change the depth selected by rotating the
spindle unexpectedly.
• To make a stop or a break from work, we will raise the machine by quickly lifting device T, fig5 to the upper
position of stalemate. This allows us to pause without losing the depth reference work soon established.

6.4 STARTING CONNECTION / DISCONNECTION

To start a machine with a gasoline engine, please proceed as follows:
• Raise the drum some centimetres from the ground, as indicated in this manual.
displace the handle until the lock pawl T, Fig.5
9
ENGLISH
reaches its top position.