Compliance Information - DJI OcuSync 2.0 Kurzanleitung

Compliance Information

FCC Compliance Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
For Remote Controller ,SAR tests are conducted using standard operating positions accepted
by the FCC with the device transmitting at its highest certified power level in all tested frequency
bands,although the SAR is determined at the highest certified power level, the actual SAR level of
the device while operating can be well below the maximum value. Before a new model is a available
for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure
limit established by the FCC, Testsfor each product are performed in positions and locations as
required by the FCC.
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines
when used with an accessory designated for this product or when used with an accessory that
Contains no metal and that positions the handset a minimum of 10mm from the body.
ISED Warning
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the
following two conditions: (1)This device may not cause interference.(2)This device must accept any
interference, including interference that may cause undesired operation of the device.
117