Checking The Firmware Version; Restoring Factory Default Settings - Tascam CD-400U DAB Bedienungsanleitung

Checking the firmware version

You can check the version of the system firmware used by this
unit.
1.
Select the Information item on the Menu screen to open
a screen where you can check the firmware version. (see
"Menu operation procedures" on page 18)
Information
MCU ver 1.01
The firmware version confirmation screen shows informa-
tion about the system firmware version.
2.
Press the main unit MULTI JOG dial or remote control ENTER
button to return to the Menu screen.

Restoring factory default settings

You can restore the various settings stored in the backup memo-
ry of the unit to their factory default values.
Use the following menu procedures to do so.
1.
Select the Factory Preset item on the Menu screen. (see
"Menu operation procedures" on page 18)
2.
Press the main unit MULTI JOG dial or remote control ENTER
button.
A confirmation message will appear.
Factory Preset
NOTE
To cancel, press the main unit CLEAR button.
3.
Press the main unit MULTI JOG dial or remote control ENTER
button to reset the unit to its factory settings.
After it completes, the Menu screen will reopen.
OK?
9 – Other functions
TASCAM CD-400U DAB
41