Special Maintenance - EMAK Oleo-Mac PWX 200C Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

MAINTENANCE

SCHEDULE

Monthly

CAUTION

• When working, the high pressure cleaner should not be too noisy and there should be no obvious

drips of water or oil underneath it. If this is the case have the machine checked by a Specialized

Technician.

Special maintenance must only be done by a Specialized T echnician, complying with the following table.

Also remember to carry out the special maintenance jobs listed in the engine operating and maintenance

manual.

MAINTENANCE

SCHEDULE

After the first 50 hours

of operation

Every 200 hours

Every 500 hours

CAUTION

• The data given in the table are approximate. It might be necessary to carry out maintenance more

frequently in the case of particularly heavy work.

• Clean the detergent suction filter (10).

It is normally enough to put the filter under running water or blow it with

compressed air to clean it. In the most difficult cases use a scale remover or

replace it, contacting an authorised assistance centre to buy the new filter.

• Clean the nozzle.

It is normally enough to put the needle (29) supplied through the hole of the

nozzle to clean it. If the results are not good, replace the nozzle purchasing

it from an authorised assistance centre.

The professional fixed fan nozzle mounted on the nozzle holder heads (24)

can be replaced using a 14 mm box spanner (not supplied).

• Oil or grease the rotating or sliding parts the operator is able to reach (refer

also to the engine operating and maintenance manual).

• Check soundness of the water inlet and outlet circuits.

• Check tyre inflation pressure.

• Check clamping of the pump to the engine and the engine to the frame.

If clamping is found to be insecure do not, under any circumstances, use

the high pressure cleaner and contact a Specialized Technician.