Cleaning And Maintenance - EMAK PW 146C Bedienungsanleitung

- the water cleaner is not in contact with inflammable materials, or in their immediate vicinity.
6.2 s
toraGe
• Wind up the high-pressure pipe (23) carefully and avoid bending it.
• Wind up the electric power supply cable (1) and hook it to its support (13).
• Put the water cleaner in a clean and dry place making sure that the electric power supply cable and
the high-pressure pipe are not damaged.
CAUTION
• The water cleaner is not frost proof.
In order to prevent the formation of ice inside the water cleaner in cold areas, it is possible to make
the high pressure cleaner take up a motor vehicle grade anti freeze before starting the " Switch off"
procedures. Contact a Skilled Technician before attempting this as the pumped liquid could damage
the seals in the high-pressure pump.
If it is not possible to protect the high pressure cleaner in cold areas as described above, it must be
brought into a warm room for the time required to melt any ice which may have formed inside it
before attempting to start it up again.
If these instructions are not followed, the high pressure cleaner may be seriously damaged.
7 c m
leanInG and
WARNING
• Only start cleaning and maintenance once the instructions in the "Switching off" section have been
completed.
It is particularly important to always disconnect the electricity supply.
• To safeguard the safety of the high pressure cleaner, only use the original spare parts supplied by the
Manufacturer or those endorsed by him.
• The rubber pipes, the coupling and the high-pressure lances are important for safety: only use those
endorsed by the Manufacturer.
7.1 r m
outIne aIntenance
Follow the instructions in the "Switching off" section and abide by the recommendations in the table
below.
INTeRvAl fOR mAINTeNANCe
Each time used
Weekly
Monthly
CAUTION
• During use, the high pressure cleaner should not be too noisy and large amounts of water or oil
should not drip from underneath it.
In this event, a Skilled Technician should test the appliance.
aIntenance
• Check the supply cable, high-pressure pipe, couplings, cleaner gun,
lance pipe.
Should any of these parts appear to be damaged, do not use the high
pressure cleaner and contact a Skilled Technician.
• Cleaning the water inlet filter
Remove the water inlet fitting (a) and remove the filter (b) with pliers
(see Fig. 6).
Cleaning the filter under running water or a burst of compressed air is usually
sufficient. For tougher dirt, use a product for removing lime scale or replace it.
Contact an authorised service centre to make sure you get the right spare part.
Replace the filter and secure the coupling fully.
• Clean the nozzle.
For cleaning, it is generally enough to pass the supplied pin (19) inside
the nozzle hole. In case you do not obtain any appreciable result, apply
to an authorised service centre.
ACTION
EN
13