Connecting An Automatic Gate Opener; Use; Settings On The Roadside Panel(S); Settings On The Monitor(S) - Extel I TOUCH Installations- Und Bedienungsanleitung

d. Connecting an automatic gate opener
Connect it directly to the terminals on the back of the roadside panel. The roadside panel supplies a current-
IMPORTANT !
This function can only be used if the screen is switched on and by pressing the key
few seconds and switches on again).
ITOUCH
C+ C-
C+ C-
ITOUCH
INT FM DATA C2- C2+ C1- C1+ GND B+
- +
INT FM DATA C1+ C1- C2+ C2- B+ GND
INT FM DATA
- +
830461
8GB CFI EXTEL ITOUCH - 12/2009 - V1
(the screen switches off a
INT
FM
DATA
C2-
C2+
C1-
C1+
GND
B+
- +
-
+
ITOUCH
INT FM DATA C2- C2+C1- C1+ B- B+
- +
C+ C-
C+ C-
REMINDER!
Carefully observe the power supply polarity.
If necessary, do not forget to modify the position of dip-switches on the back of the main monitor and to check
their good positions on the additional monitor.
Any modifications of the position of the dip-switches on the back of the main monitor and on the back of the
additional monitor must be validated by the disconnection, during 30 seconds, of the adapter.
6

USE

a. Settings on the roadside panel(s)
2 settings are accessible in the roadside panel:
- On the upper left side, setting of the sound level for the speaker of the roadside panel.
- On the upper right side, setting of the sound level for the speaker of the monitor.
WARNING : To change the settings, use a small screwdriver and turn it carefully without force to the abut-
ments.
b. Settings on the monitor(s)
Turned on screen the key
Set with the keys and
Turned off screen the key allows turning on or off the light frame;
The potentiometer allows setting the sound level of the ring tones.
c. On the monitor(s) you can choose among 4 ring tones
to enter the ring tone mode selection
.
You should perform the same operation on the additional monitor if you also want to hear the same ring tone.
d. Switching off the ring tone on the monitor(s)
.
shifts from blue to violet.
pressing the key ).
.
shifts from violet to blue.
e. Operation
If needed, remove the protective film from the screen and the camera lens
visitor is displayed for approximately 40 seconds.
key to communicate with him.
A single press on the key is enough to communicate with the roadside panel.
CFI EXTEL ITOUCH - 12/2009 - V1
and allows setting the light level.
.
9GB