Remote Control Unit - Unold 86880 Bedienungsanleitung

6. Precisely fit the stand tube (4)
onto the base (2). Ensure that
the foot switch on the base fits
precisely into the aperture on the
base intended for this purpose.
The stand tube is fixed in place
on the base with a fixing nut (1).
7. Fit the motor housing (6) onto the
stand tube (4). In this process,
ensure that the lower end of the
motor housing fits precisely onto
the holes intended for this pur-
pose. Fix the components in place
with the screw (5).
8. Fasten the rear basket cover (8)
on the motor housing (6), by
fixing the cover in place with the
nut (9).
9. Place the impeller (10) on the
axle (7) on the motor housing. Fix

REMOTE CONTROL UNIT

1. Carefully slide the cover of the
battery compartment downward.
2. Insert the batteries. In this regard,
strictly ensure that the polarity is
correct. For orientation, there are
appropriate markings in the bat-
tery compartment.
3. If you want to use batteries other
than the
always use type AAA batteries.
4. Close the cover.
5. If you adjust the appliance with
the remote control unit, ensure
that you always hold it in the
direction of the fan while you are
making the settings.
6. The designations on the remote
control unit are identical to the
provided batteries,
the impeller in place with the fas-
tening ring (11).
10. Connect the front basket cover to
the rear basket cover. Check whe-
ther the black ring is in the right
position (both halves of the bas-
ket must sit precisely in the ring)
and fix them in place with the
clamp. You can secure the clamp
by screwing the small screw into
the intended hole.
11. Check whether all parts have been
correctly assembled and fixed in
place.
designations
the buttons on the
appliance.
7. To avoid damage,
never allow
remote control unit
to fall from a signi-
ficant height.
8. On the rear of the
operating element,
there is a small hol-
der on which you
can practically store
the remote control
unit.
of
the
19