Remote Control Unit - Unold 86880 Bedienungsanleitung

5. On the base there is a small aperture for the power cord. Ensure that you
press this power cord into this aperture so that the appliance can stand
stable.
6. Precisely fit the stand tube (4) onto the base (2). Ensure that the foot switch
on the base fits precisely into the aperture on the base intended for this
purpose. The stand tube is fixed in place on the base with a fixing nut (1).
7. Fit the motor housing (6) onto the stand tube (4). In this process, ensure
that the lower end of the motor housing fits precisely onto the holes intended
for this purpose. Fix the components in place with the screw (5). Caution:
Ensure that the plug connections of parts 4 and 6 are in contact before you
connect both parts!
8. Fasten the rear basket cover (8) on the motor housing (6), by fixing the cover
in place with the nut (9).
9. Place the impeller (10) on the axle (7) on the motor housing. Fix the impel-
ler in place with the fastening ring (11).
10. Connect the front basket cover to the rear basket cover. Check whether the
black ring is in the right position (both halves of the basket must sit pre-
cisely in the ring) and fix them in place with the clamp. You can secure the
clamp by screwing the small screw into the intended hole.
11. Check whether all parts have been correctly assembled and fixed in place.

REMOTE CONTROL UNIT

1. Carefully slide the cover of the battery compartment down-
ward.
2. Insert the batteries. In this regard, strictly ensure that the
polarity is correct. For orientation, there are appropriate mark-
ings in the battery compartment.
3. Always use type AAA batteries.
4. Close the cover.
5. If you adjust the appliance with the remote control unit, ensure
that you always hold it in the direction of the fan while you are
making the settings.
6. The designations on the remote control unit are identical to
the designations of the buttons on the appliance.
20
Copyright UNOLD AG | www.unold.de