Fitting/Removing Brush Heads; Operation; Brushing Teeth - Nevadent NSZB 3.7 A1 Bedienungsanleitung

8) You can now leave the handset in the char-
ger 5 after every use, so as to always have
full power available.

Fitting/removing brush heads

To remove the brush head 1 pull it upwards
■
and off the drive shaft 2.
When fi tting the brush head 1, ensure that the
■
drive shaft 2 on the handset slides precisely
into the socket on the brush head 1. Push
the brush head 1 down until it completely
encloses the drive shaft 2.
NOTE
To avoid damage to the appliance, always use
original brush heads.
(For replacement brush heads, see the order
card)

Operation

This toothbrush has 3 diff erent performing levels:
–
"Clean": normal speed,
orange "Clean" LED 9
For cleaning the teeth.
–
"Soft": slow speed, green "Soft" LED 8
For cleaning the teeth of people with
sensitive gums.
–
"Pulse": slow speed with short breaks,
yellow "Pulse" LED 7.
For massaging the gums.
NSZB 3.7 A1
Press the on/off switch 0 once to activate the
■
"Clean" mode. The "Clean" LED 9 lights up.
■ Press once more to switch to "Soft" mode.
The "Soft" LED 8 lights up.
■ Press it a third time to switch to "Pulse" mode.
The "Pulse" LED 7 lights up.
■ To switch the toothbrush off , press the on/off
switch 0 once more.

Brushing teeth

WARNING!
Due to the unaccustomed eff ect of the tooth-
brush, there may be some initial gum bleeding.
This is normal. If this continues for more than
two weeks, you should consult your dentist.
1) Place the brush head 1 on the handset.
2) Moisten the brush under fl owing water.
3) Put a little toothpaste onto the wet brush.
NOTE
To avoid spray, do not switch on the appliance
until it is in your mouth
4) Use the on/off switch 0 to select the desired
operating mode.
NOTE
This toothbrush has a 30-second interval timer,
so that all four jaw quadrants can be cleaned
evenly.
GB
5