Pioneer DVD-R7783 Bedienungsanleitung Seite 9

TO INSTALL THE DRIVE
For instructions on how to open the access doors, see the operating instructions for the changer.
Before installation, be sure to specify the following settings at the rear of each drive to be installed.
¶ SCSI ID assignment
Specify the SCSI IDs to be used so as to ensure that the same SCSI ID is not
assigned by more than one drive on the same SCSI bus.
Warning about static electricity
Always be sure never to touch the
contacts or ports when operating
drives.
Also be sure to touch a metallic surface
on the changer before installing
additional drives to the changer.
1. When inserting a drive, be sure to
place the drive on the changer guide
rails and push the drive in until the
lock lever on the drive shifts to the
locked position. Maybe you can hear
a clicking sound then.
Drive
Lock lever
When a drive is to be removed from the
changer, flip the lock lever to the released
position and then pull the drive out from the
changer.
2. Connect the power cable.
¶ When the power cable has been
connected, the wiring monitor indicator on
the rear of the drives (orange) will light up.
Wiring monitor indicator
3. Connect the changer interface cable.
Guide rails
NOTE:
Connect the changer interface cable to the
connector corresponding to the bay in which
the drives have been installed. (Note that labels
are affixed to connectors indicating the
corresponding bay number.) Note that it is
extremely important to do this, as connecting
the changer interface cable to a neighboring bay
will result in damage to discs and the disc
transport mechanism.
4. Connect the LVD drive connector
Power cable
¶ When the changer interface cable has
been connected, the wiring monitor
indicators will flash at two-second
intervals.
Wiring monitor indicator
Changer interface cable
panel.
Connect the optional LVD drive connector
panel (DRM-LN721, for 2 drives; or DRM-
LN741, for 4 drives).
LVD drive connector panel
9
En