Rear View; Front View - Pioneer DVD-R7783 Bedienungsanleitung

A HARDWARE TOUR

REAR VIEW

12
SCSI
ID
6
1 Busy indicator
Lights when drive is busy.
2 Wiring monitor indicator
Meaning of indicator when indicator is
lit up:
¶ Lights when drive has been installed in
changer and power cable is connected.
Meaning of indicator when indicator
flashes in 2-second intervals:
¶ This indicator flashes in 2-second
intervals when the drive is installed in a
changer and its changer interface cable
has been connected.
Meaning of indicator when indicator
flashes in 0.5-second intervals:
¶ This indicator flashes in 0.5-second intervals
when the drive in question has been
specified as the drive to be swapped during
the swapping of drives.
3 Changer interface cable
This cable must be connected to the changer
interface connector located in the changer.
4 Power cable
This cable must be connected to the power
inlet located in the changer.
5 Lock lever
When a drive is to be removed from the
changer, flip the lock lever to the released
position and then pull the drive out from the
changer.
8
En
3
WIRING MONITOR IND
BUSY IND
5 1
7
4
6 SCSI ID switch
Set the Drive SCSI ID. Press the upper
button to decrement the number, and the
lower button to increment the number.
Factory default: "0".
7 LVD SCSI interface connector
Use to connect an optional LVD drive
connector panel (DRM-LN721, for 2 drives;
or DRM-LN741, for 4 drives).
NOTE:
Be careful not to allow any part of your body to
come into contact with connector pins, as doing
so may result in faulty connections or damage from
static electricity.

FRONT VIEW

8 Busy indicator
Lights when drive is busy.
5
RELEASE
LOCK
8