Installation Precautions - Pioneer DVD-R7783 Bedienungsanleitung

INSTALLATION PRECAUTIONS

The following special precautions should be taken into consideration if this unit is to be
installed in a changer:
÷ This unit is an LVD SCSI drive. If this drive is to be installed on the same SCSI bus
with an SE SCSI drive and the main changer unit, the optional LVD SCSI interface
unit (DRM-ULV16) should be used.
÷ When making the LVD SCSI connections for this unit, an optional LVD drive connector
panel (DRM-LN721: supports two drives; or DRM-LN741: supports four drives) should
be used. Consult the Operating Instructions accompanying the LVD drive connector
panel regarding procedures for installing the connector panel to the changer.
÷ The number of drives and DVD-D7563 that can be installed in the changer are as
follows:
Changer Ambient
Model temperature (DVD-D7563 and DVD-R7783) DVD-R7783 units DVD-D7563 units
5°C – 30°C
DRM-7000
30°C – 35°C
5°C – 30°C
DRM-3000
30°C – 35°C
Please consult your dealer when installing optional drives other than those listed
above, or when adding this drive to a changer already in use.
÷ This drive is not equipped with an SCSI terminator (LVD).
When there is a need for LVD SCSI termination, use the optional SCSI Terminator
(LVD) DRM-TM160 or the SCSI Terminator (LVD) provided with the LVD SCSI interface
unit DRM-ULV16.
÷ This unit cannot be installed in a DRM-7000 when the latter has been equipped with
the Power supply unit DRM-PW701.
÷ This unit can be installed in any of bays #1 to #8 on the DRM-7000 or DRM-3000.
Connection method
Same bus
Separate buses
Same bus/separate bus
Same bus/separate bus
Same bus/separate bus
Maximum Maximum
1 – 3
4
1
2
3
4
1
2
3
4 None
1
2
3
4 None
1
2
3 None
3
2
5
4
3
2
3
2
1
3
2
1
2
1
7
En