Troubleshooting - EINHELL GE-EC 2240 Originalbetriebsanleitung

Anleitung_GE_EC_2240_SPK7__ 28.04.14 15:08 Seite 23

13. Troubleshooting

Caution!
Before troubleshooting, switch off the tool and disconnect the mains plug.
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your
tool fails to work properly. If the problem still persists after working through the list then please contact your
nearest service workshop.
Cause
Chainsaw does not work
at all
Chainsaw operates
intermittently
Saw chain dry
Chain brake does not
work
Chain/guide rail hot
Chainsaw juddering,
vibrating or not sawing
properly
Fault
Quick stop brake has been triggered
No power supply
Defective mains outlet
Power extension cable damaged
Defective fuse
Power cable damaged
Loose connection (external)
Loose connection (internal)
ON/OFF switch defective
No oil in the tank
Oil tank cap breather blocked
Oil outlet blocked
Problem with the switch mechanism in
the front hand guard
No oil in the tank
Oil tank cap breather blocked
Oil outlet blocked
Blunt chain
Chain tension too loose
Blunt chain
Worn chain
Saw teeth pointing in the wrong direction Reinstall the saw chain with the teeth
Remedy
Pull the hand protection back to the
normal position.
Check the power supply.
Try an alternative source of electrical
power, replace if necessary.
Check the cable and replace as
required.
Replace the fuse.
Consult a specialist workshop.
Consult a specialist workshop.
Consult a specialist workshop.
Consult a specialist workshop.
Fill up with oil.
Clean the oil tank cap.
Clear the oil outlet.
Consult a specialist workshop.
Fill up with oil.
Clean the oil tank cap.
Clear the oil outlet
Re-sharpen or replace the chain.
Adjust the chain tension.
Re-sharpen or replace the chain.
Replace the chain.
facing in the correct direction.
GB
23