General Operation; Hold Function - Velleman VTBAL38 Bedienungsanleitung

4. Overview
Refer to the illustrations on page 2 of this manual.
1
weighing platform
2
on-off button
3 mode button
5. Battery
We recommend using a power adapter if you plan using the scales on a regular basis. If not, powering
the scales with batteries will suffice.
To insert the batteries, proceed as follows:
1. Open the battery compartment of the weighing platform by sliding the cover toward the outside.
2. Insert two AAA batteries according to the correct polarity.
3. Close the battery compartment.
Remark: Remove the batteries or disconnect from the mains if the scales will not be used for a longer
period.

Do not puncture batteries or throw them in fire as they may
explode. Do not attempt to recharge non-rechargeable batteries
(alkaline). Dispose of batteries in accordance with local regulations.
Keep batteries away from children.

The deported display does not need any powering.

Replace the batteries as soon as the display shows "L-o".
6. Operation
6.1

General Operation

1. Place the scales on a levelled surface.
2. Press the on-off button to switch on the scales.
3. Place the item on the platform and wait until the reading on the display is stable.
4. Switch off the scales after use. Note that the scales will switch off automatically 5 minutes after the
last operation.

The scales are overloaded as soon as the display shows "O-Ld".
Remove the item from the platform.
6.2 Unit Selection
1. Switch on the scales.
2. Press the mode button to select the weighing unit.
6.3 Tare Function
1. Switch on the scales.
2. Place the tare item on the platform.
3. Press the tare button once and wait for the display to show "0.00".
4. Add the net weight.
6.4

Hold Function

1. Switch on the scales and weigh the item.
2. Press the hold button to freeze the weight on the display.
V. 01 – 18/07/2017
VTBAL38
4
hold button
5
tare button
WARNING
WARNING
4 ©Velleman nv