Sanus VMF322 Anleitung Seite 8

2 Mount the Wall Plate
Wood stud
2-1 Locate stud
2-2 Mark the wall
[03]
2-3 Drill pilot holes
2-4 Insert the top wall plate lag bolt
[06]
8
< 16 mm
(5/8 in.)
OPT
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1½ x 3½ in.).
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate template
third hole is for the cable management clamp [19] and is optional.
CAUTION:
Avoid potential injuries or property damage! Pilot
holes MUST be drilled to a depth of
(7/32 in.) diameter drill bit. Only pre-drill the top two holes.
75 mm
(3 in.)
Insert only the top plate lag bolt [06] at this time.
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage:
DO NOT over-tighten the lag bolt [06].
13 mm
5½ mm
(1/2 in.)
(7/32 in.)
[03] and mark the hole locations. The
75 mm (3 in.), using a 5½ mm
6901-002142 05
OPT