Inhaltsverzeichnis
Werbung
TABLE 2 - TABLEAU 2 - TABELLE 2 -
85
TABLA 2 - TAVOLA 2 (ITEM 20)
83
62
63
35
82
40
51
47
49
40
42
48
66
50
46
47
04
52
03
206
02
34
33
74
75
43
36
43
38
44
45
41
205
84
37
201
08
61
200
31
2.5) Battery status
After releasing the operating button, the residual battery
capacity is automatically displayed for 5 seconds on the
indicator (04).
The number of LEDs illuminated indicates the residual
capacity:
10 LEDs illuminated: fully charged
5 LEDs illuminated: 50 % capacity
1 LED illuminated: minimum charge
3. WARNING
T
HE TOOL IS UNSUITABLE FOR CONTINUOUS USE AND SHOULD BE ALLOWED TO
COOL DOWN FOLLOWING UNINTERRUPTED
,
INSTANCE
HAVING EXHAUSTED A FULLY CHARGED BATTERY IN ONE SESSION
BATTERY REPLACEMENT FOR A FEW MINUTES
O
BSERVE RECOMMENDED REST PERIODS ALSO WHEN USING AN EXTERNAL POWER
.
SUPPLY
D
O NOT USE THIS TOOL ON LIVE CABLES
P
ROTECT THE TOOL FROM RAIN AND MOISTURE
. E
-
BATTERY
LECTRO
HYDRAULIC TOOLS SHOULD NOT BE OPERATED IN POURING
.
RAIN OR UNDER WATER
3.1) Using the battery charger
Carefully follow the instructions in the battery charger manual.
3.2) General information on how to use batteries
In order to use the batteries correctly, please follow these rules:
– Use the battery until the automatic residual energy display still has 1-2 LEDs showing:
this means the battery is almost completely discharged and no loss in the life of the
battery has been caused.
– Be particularly careful when charging a new battery the fi rst 2-3 times in order to be
certain of maximising the available energy level.
– Allow the battery to cool down to ambient temperature prior to recharging.
– Rest the battery charger for at least 15 minutes between charges.
4. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance
of the tool:
4.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any
residual particles, especially close to pivots and moveable parts.
4
ENGLISH
04
,
;
SUCCESSIVE CUTTING OPERATIONS
FOR
,
DELAY
.
.
. W
ATER WILL DAMAGE THE TOOL AND
Werbung
Inhaltsverzeichnis
