Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning; Troubleshooting; Notice Regarding Conformity; Importer - Silvercrest KH 2218 Bedienungsanleitung

Projektionswecker
Vorschau ausblenden Andere Handbücher für KH 2218:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 51
Dimming the Display
You can adjust the display brightness in three
levels by pressing the SNOOZE /
Dimmer Control button f.
Projection
The time can be projected from the appliance
onto a wall or the ceiling. This function is in-
tended for reading the time in darkness.
During the day in well lit rooms you will hard-
ly be able to use the projection facility.
1. For this, first fold the projector u out.
2. Switch the function on with the Projection
button r.
3. Direct the projector u onto the desired
surface area.
4. Using the focus regulator k sharpen the
image.
5. The time will now be projected onto the
desired surface area for the pre-adjusted
timespan (see section "Adjusting the Pro-
jection duration").
6. Should you wish to switch this function off
prematurely, press the Projection button r
and fold the Projector in.

Cleaning

Warning!
Always remove the mains power plug
before cleaning the appliance! Moisture
penetrating into the appliance creates
the risk of electric shock! Additionally,
the appliance could become irreparably
damaged!
Clean the housing of the radio alarm only
with a slightly moist cloth and a mild deter-
gent. Ensure that moisture cannot permeate
into the appliance during cleaning!

Troubleshooting

The appliance doesn't work.
>
Is the plug of the power cable
firmly into the power socket?
>
Has the circuit breaker tripped?
>
Is there a power cut?
Poor VHF reception.
>
Change the alignment of the wire aerial
l. If necessary, firmly position it with
adhesive tape.
Poor MW reception.
>
Change the alignment of the appliance.
Loss of all programming after a power
cut.
>
Batteries were not inserted to retain the
memory.
>
The batteries inserted for memory retenti-
on are exhausted. Replace them.
The projected time is difficult to read.
>
Using the focus regulator
image.

Notice regarding conformity

This appliance has been tested against, and
found to be in compliance with, the funda-
mental requirements and other relevant stipu-
lations of the EMC Directive 2004/108/EC,
as well as the Guidelines of the Low Voltage
Directive 2006/95/EC.

Importer

KOMPERNASS GMBH
BURGSTRASSE 21
44867 BOCHUM, GERMANY
www.kompernass.com
- 34 -
1( inserted
k sharpen the

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Spu 900 a1

Inhaltsverzeichnis