Concept RM 4420 Bedienungsanleitung Seite 48

EN
MINCER
IMPORTaNT:
• DO NOT TRY TO ATTEMP TO USE THIS FUNCTION TOGETHER WITH BLENDING
OR MIXING.
1. Cut all foods into pieces (Sinewless, boneless and fatless beef or pork is
recommended, approximately size :20×20×60 mm) so that they fit easily
into the hopper opening.
The ingredients would avoid bone or hard stuff with it, hard stuff or bone
would cause the motor seized. If the engine is seized, please stop the unit
and disassemble the mincer assembly to take out the bone or hard stuff,
if the motor is stopped automatically, after the motor is cooled down, the
function would restore.
2. Assemble the mincer as below description, turn on the unit at speed 6;
3. Feed foods into the tray (16). Use for it only the food pusher (15).
4. After using, turn the switch (3) to "0" and unplug it from the power supply.
5. Use less than 6 minutes continuously at a time.
How to assemble the mince
• Remove the front cover. (Fig 1)
• align and turn the chute in anti-clockwise direction , until the mincing tube
is in place firmly. (Fig 2)
• Put a meat container below the chute.
• Set the speed control to position 6. Then place the desired foodstuff into the
tray and use the pusher to push the food into chute. (Fig3)
• After use, switch off the appliance and unplug it.
• Press the mincer locking button, turn the mincer clockwise and remove the
mincer assembly. (Fig4)
• Cover the front cover. (Fig5)
48
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
RM 4420 RM 4421