Bellelli Maximo Bedienungsanleitung Seite 18

For the versions equipped with isofix attachment points
Release the attachment points (N) by pressing the red button (Fig. 14).
Place the attachment points (N) underneath the product's seat (G).
How to position the child in the seat
Press adjuster (J) and simultaneously pull both the harness straps (E)
of the child seat (Fig. 15).
Press the red buckle button (K) to open it (Fig. 16).
EN
Open the straps and lay them on the sides of the child seat.
Sit the child in the child seat.
Bring the two harness tongues together and insert them into the buckle
(K). A click indicates when the buckle is closed correctly (Fig. 17).
Position the padding sections (C) on the shoulders and chest of the
child, pulling them downwards (Fig. 18).
Pull the adjuster strap (H) to tighten the safety harness (E) snugly
over the child (Fig. 19).
Warning: During the journey periodically check that the child has not
freed itself from the child seat.
How to free the child from the seat
Press the adjuster (J) and simultaneously pull both the harness straps
(E) to loosen them (Fig. 20).
Press the red buckle button (K) to open it (Fig. 21).
Take off the straps and clear them from the child.
Groups 2 and 3 (from 15 to 36 kg) with backrest
Remove the child seat harness before using it for groups 2 or 3.
How to remove the car seat harness
Release both harness straps (E) from the metal yolk (O) and unthread
them from the backrest (Fig. 22).
Unthread the padding fixture plates (R) from the backrest (D) (Fig. 23).
Turn the child seat over and completely unthread the straps (E) (Fig.
24).
Pass the metal clip (K) of the buckle through the hole in the seat and
unthread the buckle (G) from the child (Fig. 25).
How to position the child in the seat
Position the child seat on the seat of the vehicle so that it is fully
supported on the seat and backrest.
For the versions equipped with isofix attachment points
Fix the isofix attachment points (N) as shown in the section How to
use the isofix attachment points.
Warning: The car seat belt routing positions are marked in red. Do not
route the car seat belt in positions other than those indicated.
Sit the child in the child seat.
Position the diagonal section of the car seat belt over the child's chest
and pass it under the seat armrest (F) (Fig. 26).
Insert it into the belt guide (B) (Fig. 27).
Pass the lap section of the car seat belt under the two armrests of the
seat (F) (Fig. 28).
Tension the car seat belt well, check that there are no twists and that it
runs smoothly under the armrests of the child seat (F).
Close the car seat belt.
Warning: During the journey periodically check that the child has not
freed itself from the child seat.
How to free the child from the seat
Release the car seat belt, unthread it from the child seat and allow
16