Bellelli Maximo Bedienungsanleitung Seite 17

How to use the child seat
Position the child seat on one of the vehicle's rear seats or on the
front passenger seat.
Warning: in certain countries the highway code do not allow child
seats to be installed on the front seats: Check the highway code in
your country.
Warning: do not use the child seat on the front passenger seat if the
vehicle is equipped with an active passenger side airbag.
Warning: do not place the child seat on a seat that it only fitted with
a lap belt.
Warning: do not put anything between the child seat and the car seat.
Warning: for the versions equipped with isofix attachment
points, fasten the child seat and the child to the child seat with
the car's seat belts even when using isofix attachment points.
For the versions equipped with isofix attachment points
How to use the isofix attachment points
Remove attachment points (N) from underneath the seat (G) (Fig 6).
Press the adjuster (M) and simultaneously pull the isofix attachment
(N) backwards (Fig 7).
Fix the isofix attachment point to the isofix yolks located on the
vehicle's seat (Fig 8).
Pull the belt (L) and simultaneously push the child seat towards the
backrest (Fig 9).
Tension the belt well and check that there are no twists.
Check that the child seat is securely fastened to the vehicle's seat and
that it is fully supported on the seat and backrest of the vehicle's seat.
Secure the child seat with the vehicle's seat belts (see section Group
1, Group 2 and 3 with backrest and Group 3 without backrest).
Warning: for the versions equipped with isofix attachment
points, fasten the child seat and the child to the child seat with
the car's seat belts even when using isofix attachment points.
Group 1 (from 9 to 18 kg)
Position the child seat on the seat of the vehicle so that it is fully
supported on the seat and backrest.
For the versions equipped with isofix attachment points
Fix the isofix attachment points (N) as shown in the section How to
use the isofix attachment points.
Warning: The car seat belt routing positions are marked in red. Do not
route the car seat belt in positions other than those indicated.
Pass the diagonal section of the car seat belt across the upper part of
the backrest (D) (Fig. 10).
Pass the lap section of the car seat belt under the armrest of the child
seat (E) (Fig. 11).
Pass both straps through the openings in the child seat backrest (D)
(Fig. 12).
Pass both of them under the armrest of the child seat (E).
Close the car seat belt (Fig. 13).
Tension the car seat belt well, check that there are no twists and that
it runs smoothly under the armrests of the child seat.
How to remove the child seat
Release the car seat belt, unthread it from the child seat and allow
it to retract.
15
EN