Video Recording Mode - Z-EDGE S3 Bedienungsanleitung

VIDEO RECORDING MODE

Motion Detection
With "Motion Detection" enabled, video recording is automatically paused
when no movement is detected by the front view camera or G-Sensor. Video
recording will automatically start again when movement is detected. This
feature can be disabled or enabled with Off/On options inside the menu: Feature
Setting -> Motion Detection.
Loop Recording
Videos are recorded and saved to the memory card as multiple video clips.
Once the memory card is full, the "Loop Recording" feature automatically
overwrites the earliest unprotected saved file. This prevents long duration video
clips from being lost in a single overwrite. Video clip duration can be set to 1, 3
or 5 minutes inside the menu: Menu Setting -> Loop Recording.
Crash Detection
In the event of a collision the "Crash Detection" feature, triggered by the highly
sensitive built-in G-Sensor, will automatically turn video recording on and
protect the saved file. The sensitivity of the G-Sensor can be set to Off, Low,
Normal or High inside the menu: Feature Setting -> G-Sensor Sensitivity.
Parking Mode
When "Parking Mode" is enabled, the device continues to monitor the vehicle
while it is turned off and parked. If any motion or vibration is detected by the
device, it will automatically turn on and begin recording. Approximately 30
seconds after the motion or vibration has finished, the device will automatically
turn off and return to monitoring mode.
In "Parking Mode" the device is powered by the internal rechargeable battery,
and the LCD display screen is automatically set to power save to conserve battery
power. This feature can be set to Off or On inside the menu: Feature Setting ->
Parking Mode.
7