Using The Car Dash Cam; Recording Videos; Recording Screen - Z-EDGE F1 Bedienungsanleitung

3 Using the Car Dash Cam

3.1 Recording Videos

With an SD card inserted and the device connected to power, when the car
engine is switched on the dash cam will automatically power on and start
recording. When the vehicle engine is switched off, the dash cam will
automatically save the recording and power off within 10 seconds.
Alternatively, short press the 'OK' button (8) to stop/start video recording
manually.

3.2 Recording Screen

No. Item
1 Recording
2 Resolution
3 Recording Time
4 IR Mode
5 Loop Recording
6 Motion Detection Motion Detection : On/Off
7 GPS
1 2
5
6
7
8
9
Description
A flashing red dot indicates the Dash cam is
currentlyrecording.
Indicates the current video resolution.
Indicates the current video recording time.
Indicates the IR night vision setting,On/Off/Auto,
press and hold the 'Up' button (3) for 4 seconds to
change the IR mode.
Loop Recording setting.
Blue: Searching for GPS signals.
Green: GPS working status.
-8-
3 4
10 11 12
13