Panasonic CF-VEB311U Bedienungsanleitung Seite 12

Connecting/Disconnecting
6
Press down lightly on the rear
corners of the computer onto
the Port Replicator guide pins.
E
CAUTION
●
D o n o t a t t e m p t t o m a k e
connections if there is any object
between the computer and the
Port Replicator. Doing so could
damage the computer and the
Port Replicator.
7
Slide the lever until it exceeds
the mark of the "DOCK", as
shown below to connect the
expansion bus connector
o f t h e P o r t R e p l i c a t o r .
(If necessary, lock the connection
by the anti-theft key.)
12
NOTE
●
The security lock key is also used
to prevent loss.
CAUTION
●
Do not attempt to move the Port
Replicator when it is connected to
the computer.
●
Set the Port Replicator up on a
flat surface. Setting up the Port
Replicator on an uneven surface can
result in poor contact.
●
Do not use the Port Replicator in a
location where it will be subject to
vibration, such as while riding a bike,
motorcycle, or car. The computer may
disconnect from the Port Replicator
and malfunction as a result.
●
If the computer malfunctions while
the Port Replicator is connected,
refer fi rst to the "Trouble Shooting
(Advanced)" in the computer's
"Reference Manual". If you still are
unable to solve the problem, turn off
the computer, disconnect the Port
Replicator ( page 13), connect the
AC adaptor to the computer, and
check to see if the computer operates
normally. If the computer operates
normally, the Port Replicator may be
malfunctioning. Contact Panasonic
Technical Support.