Bellelli Leonardo Bedienungsanleitung Seite 19

Warning: make sure the straps are not twisted
and the metal buckle cannot be pulled out of the
backrest.
Adjusting the position of the buckle (Fig. 14)
The buckle (I) can be set in four different
positions (fig. 14).
Adjust the position of the buckle so that it is
always in the hole nearest the child.
Adjust the length of the strap so that the buckle
does not create discomfort on the legs of the child.
To adjust the position and length of the buckle:
• Take the metallic plate that holds the buckle
• Pass it through the holes in the seat until it
reaches the desired position.
Use of the child seat (Fig. 15)
Group Position of the child seat on the
car seat (fig. 15)
0+ rear-facing in relation to the
forward direction of travel of the
vehicle.
1 forward-facing in relation to the
forward direction of travel of the
vehicle.
Position the child seat on one of the vehicle's
rear seats or on the front passenger seat.
Warning: Regulations in certain countries do not
allow child seats to be installed on vehicle front
seats: Check the law in your country before
proceeding.
Warning: Do not use the child seat on the front
passenger seat if the vehicle is equipped with
an active passenger side airbag.
Warning: Do not fit the child seat on a seat that
only has a lap belt.
Warning: Do not put anything between the child
seat and the car seat.
Group 0+ (children up to 13 kg) (Fig. 16 - 22)
Notice: Use the newborn insert (G) for babies of
less than three months.
Warning: the child seat must be installed in a
rear-facing position with respect to the forward
direction of travel of the vehicle.
How to fit the child seat (Fig. 16 - 22)
Pull the child seat forwards to recline it fully.
Rotate booster lever (N) until it is fully extended
(fig. 16).
Place the child seat on the car seat. Push the
front of the child seat base against the backrest
of the car seat (fig. 17).
Check that the seat is locked in the new
position. Make sure booster lever (N) and base
(O) are firmly located on the car seat.
Warning: The car seat belt routing positions are
marked in light blue. Do not route the car seat
belt in positions other than those indicated.
Identify the car seat belt routing points.
Thread the lap section of the car seat belt
through both guides (L) located at the front of
the child seat base (fig. 18).
Fasten the car seat belt (fig. 19).
Route the diagonal section of the car seat belt
over the child seat (fig. 20).
Thread the diagonal section of the car seat belt
through the belt guide located on the same side
as the car seat belt retractor reel (fig. 21).
Warning: Tension the car seat belt carefully to
take up any slack.
Warning: Check there are no twists in any
sections of the car seat belt.
Warning: after fastening the car seat belt
check the position of the buckle. The correct
position is shown in fig. 22. If the buckle is in
a different position, shift the child seat
sideways on the car seat until finding the
correct position. If you are in doubt, seek
assistance from the manufacturer or retailer.
TIPS
If the car seat belt seems to be too short:
• make sure the child seat is properly located
against the backrest of the car seat;
• if it is adjustable, move the car seat to its
fully backward position;
• if an adjustment is provided, adjust the car
seat belt height to the lowest possible
position.
How to remove the child seat from the car
Unbuckle the car seat belt.
Pull the belt off the child seat and allow it to retract.
17
EN