Programming Remote Control - STARLINE ROLDECK Anleitung

5.3 Programming Remote Control

The remote control transmitter is pre-
programmed.
If the transmitter is replaced, or if the number
of transmitters is expanded, follow the
procedure below.
Make sure that the transmitter and
the receiver will not be more than
5 meter distance from each other
during programming.
To register the remote control, enter the menu
settings of the S-Switch by pressing the the
middle key "light symbol" for 3 seconds.
With the arrow keys  or  of the S-Switch
all other menu items can be selected.
Select the symbol "Antenna" and confirm
this by pressing the "lamp symbol".
The symbol "Antenna & Remote Control" is
now active.
To program the transmitter keep one of the
four buttons pressed on the remote control.
When the transmitter is recognized,
the menu "Program channel" closes
immediately.
Transmitter / receiver have been
programmed.
Up to 8 transmitters can be programmed.
In the right bottom of the display the
number of programmed transmitters is
shown.
Manual del usuario Starline Roldeck
OR
1 sec.
RDCM V03-1015
!
8/8
107