Herunterladen Inhalt Inhalt Diese Seite drucken

Technical Data; Electric Drive Unit - EINHELL Power X Change Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Note:
The enclosed manual from provides detailed
technical data on the speedometer.
Voltage: ......................................................... 36V
Power: ........................................................ 250W
Operating temperature: ................ -10°C to 40°C
Storage temperature: ................... -20°C to 50°C
Weight approx.: ............................................16kg
Protection type: ............................................IPX4
Frame size: ........................................ 17.5 inches
Tire size: ............................................ 27.5 inches
Pushing/starting assistance up to: ...............6 kph
Pedal assistance up to: .............................25 kph
Gear selector: ..........................................8 gears
Maximum permissible gross weight .........120 kg
Maximum vehicle payload: .........................100 kg
Tightening:
Saddle:.........................................................8 Nm
Rear wheel:................................................45 Nm
Handlebar:...................................................6 Nm
Stem:............................................................6 Nm
Important!
The equipment is supplied without batteries and
without a charger and is allowed to be used only
with the lithium-ion batteries (two batteries) of the
Power-X-Change series!
The lithium-ion batteries of the Power-X-Change
series are allowed to be charged only with the
Power-X charger.
Power X-Charger charger
Mains voltage ....................200-250 V ~ 50-60 Hz
Output
Rated voltage ........................................ 21 V d. c.
Rated current ........................................ 3000 mA
Protection Class ............................................ II/
Anl_PXC_Bike_SPK7.indb 30
Anl_PXC_Bike_SPK7.indb 30
GB

5. Electric drive unit

Pushing/starting assistant:
The pushing/starting assistant can help make it
easier for you to push or start the electric bike.
Do not use the pushing assistant for cycling. Your
electric bike has a pedal assistant for up to 25 kph
and is also equipped with a pushing assistant.
This is restricted to 6 kph.
If you actuate the pushing assistant, you will be
able to push your electric bike out of an under-
ground parking garage or up a steep section with
ease.
To switch on the pushing/starting assistant, press
the minus button (-) for 2 seconds. The pushing/
starting assistant will switch off when you release
the minus button (-) or when the speed exceeds
6 kph.
Information about the way in which the drive
unit on your electric bike works and its range
is provided here:
Mode of operation
When you have switched on one of the assis-
tance modes on your controls, the motor will start
to run as soon as you start to pedal.
The output of the motor is dependent on:
the assistance mode; the higher the assistance
level, the more the assistance you will be given
from the motor. A high motor output also means
high electricity consumption, however. In the
weakest assistance mode the thrust is at its
lowest, but on the other hand it gives you the big-
gest range.
Range
Any ranges which are given are ranges which are
achievable under optimum conditions. In every-
day use you will not normally be able to ride so
far. Please bear this in mind when planning your
tour. The range is dependent on a number of fac-
tors. In addition to the capacity of the recharge-
able battery, other critical factors include the se-
lected motor assistance, geographic conditions,
road surface, riding style, ambient temperature,
weight of the rider, tire pressure and the technical
condition of your electric bike.
Cycling without drive assistance
You can also cycle on your electric bike without
using drive assistance by setting the assistance
mode to 0.
- 30 -
13.08.2018 13:01:08
13.08.2018 13:01:08

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis