BMW Cruise Bike Bedienungsanleitung Seite 41

Disconnecting the shifting cable when removing the rear
wheel.
In the case of the CRUISE, the rear wheel is secured to the frame
with nuts. Before removing the rear wheel, it is necessary to
disconnect the shifting cable.
1. Set the shifting lever to 1 (a).
2. Hold the rubber cover and pull the outer casing holder out from
the outer casing holder section of the cassette joint (b1). Remove
the rubber bellows portion of the inner cable from the slit in the
bracket (b2). Be careful not to damage the rubber bellows at this
time.
3. Remove the inner cable fixing bolt unit from the cassette joint
pulley (c).
a
c
b
4.4 Seat height.
Configuring the height: Place the seatpost in the seat tube. Once
you have established the desired height, re-fasten the seat clamp
lever (Cruise) or screw (M-Bike).
Warning: You should not see the mark for the minimum height
at any time (d). In order to guarantee that it is safe, you should
insert the seat post well into the seat tube.
d
EN
39