System - Edirol PCR-30 Bedienungsanleitung

Edit mode (EDIT)

SYSTEM

Here's how you can make various system settings for the PCR-30/50/80.
fig.edt
1
Press the [EDIT] button.
The display will indicate "EDT".
2
Press the [SYSTEM] key.
The display will indicate "SY0".
fig.sy0
3
Use the [0]–[8] keys to specify the System setting that you want to set,
and then press the [ENTER] button.
Confirm what's indicated and use the appropriate method to make
the setting.
Key-
Mode
board
0 F8 CLOCK ON/OFF
1 F8 CLOCK DEFAULT
TEMPO
2 F8 CLOCK PORT SET
3 VELOCITY OFFSET
4 KEYBOARD PORT SET
5 H-ACTIVITY ON/OFF
6 USB DRIVER MODE
7 STARTUP MEMORY
8 FACTORY RESET
154
Content of the setting
Specify whether F8 Clock is to be
transmitted.
If "F8 CLOCK ON/OFF" is ON,
specify the default value of the F8
Clock. After the power is turned on,
this tempo will continue to be output
until you move a controller to which
TEMPO is assigned.
If "F8 CLOCK ON/OFF" is ON,
specify the port from which the F8
Clock is to be transmitted.
The value you specify here will be
added to the velocity of the notes
played from the keyboard.
* If the result of the addition would
exceed 7FH, the velocity will be 7FH.
Specify the port from which
messages produced by the BENDER
lever of the keyboard are to be
transmitted.
Turn this ON if you are using certain
applications (such as Pro Tools LE).
When ON, "90 00 7F" will be output
from PCR 2 approximately every
500 ms.
Specify the type of driver used
for USB connection.
Specify the memory that will be
selected when the power is turned
on.
Restore all settings of the PCR-30/
50/80 to their factory-set condition.
Setting
Default
method
OFF A (p. 155)
120 B (p. 155)
PCR 1 C (p. 155)
0 B (p. 155)
PCR 1 C (p. 155)
OFF A (p. 155)
Original D (p. 156)
Driver
GM2 E (p. 156)
- F (p. 156)