Sys Ex. Assign - Edirol PCR-30 Bedienungsanleitung

Edit mode (EDIT)

SYS EX. ASSIGN

Here's how you can assign a system exclusive message to a controller. Advanced mode 2 lets you
assign a single-byte system message (System realtime message, tune request).
Advanced modes 3 and 4 let you assign any desired message.(Input up to 24 bytes)
Mode
number
Basic mode
Advanced
mode 1
Advanced
mode 2
Advanced
mode 3
Advanced
mode 4
SYS EX. ASSIGN can calculate the checksum automatically, and lets you specify a variable (data)
range or embed a channel/block number within the message. ("Sys Ex. ASSIGN items" (p. 160))
In SYS EX. ASSIGN, the input mode will be HEX mode.
fig.edt
1
Press the [EDIT] button.
The display will indicate "EDT".
2
Slightly move the controller to which you want to assign the system exclusive message. In the
case of a button, press that button.
fig.r-1
The display will indicate the number of the selected controller.
3
Confirm what's indicated, and press the [ENTER] button.
fig.se0
4
Press the [SYSTEM Ex.] key.
5
If you want to select an Advanced mode, press a key from [1] to [4].
The selected mode will blink in the display.
6
Confirm what's indicated, and press the [ENTER] button.
fig.f0
For Basic mode or Advanced mode 1
The display will blink "F0", which is the first byte (starting status byte)
of a system exclusive message. (This cannot be changed.)
7
Confirm what's indicated, and press the [ENTER] button.
8
Use the [0]–[F] keys to input the second byte.
9
Press the [ENTER] button.
140
Key-
Mode
board
0 Sys Ex. message
1 Sys Ex. message
2 Single byte system message –
3 Any desired MIDI message
4 Any desired MIDI message
Value range Required ending
Default range Input F7
Assignable Input F7
–
Specified number of
Default range
bytes
Specified number of
Assignable
bytes
Notes/restrictions
1st byte fixed at F0
1st byte fixed at F0
[0–5, 7, 9, D, E ] [DATA]
[CHECKSUM] buttons
are invalid
[CHECKSUM] button is
invalid
[CHECKSUM] button is
invalid