Panasonic WV-Q126E Handbuch Seite 10

10. Mount the camera mounting stage on
the mounting chassis.
1
Insert the camera mounting stage
flanges (3 flanges) into the flange slots
(3 slots) in the camera mounting chas-
sis. Push it into the mounting chassis
as far as it will go.
2
Once it is inserted into the mounting
chassis, rotate it clockwise until it con-
tacts the mounting chassis's turn stop-
per.
Caution: If it is difficult to move,
grasp the flanges and legs and
rotate.
3
Insert and tighten the 3 screws you
removed in Step 4. * Refer to <Fig.A>
(Recommended tightening torque:
1.57 N m {16 kgf
•
4
Insert and tighten the 3 screws you
removed in Step 4. * Refer to <Fig.B>
(Recommended tightening torque:
1.57 N m {16 kgf
•
Important: Do not let the cables be
caught during installation work.
10
cm})
•
cm})
•
Slots for the camera mounting stage flanges
* 1 position on the rear side
3
1
2
3
2
<Fig A>
4
4
<Fig.B>
Turn stopper
* 2 positions
on the rear
side
3
1
Legs
2
Flanges
4