Operation; Spare Parts - HANSGROHE Mondial 15001 Serie Montageanleitung/Garantie

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand.
4. Tighten screws.
5. Connect the connecting hose to the angle
valves; cold right - hot left.
6. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply should be balanced.

Operation

The mixer is actuated by lifting the lever head.
Swivel to the left = hot water, swivel to the right =
cold water.
15200XXX: Swivel range of spout ± 20°.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 8a) located behind the mousseur must
be removed.
To adjust the hot water limiter on single lever mixers,
please see page 2.
No adjustment is necessary when using a
continuous flow water heater.
6
English

Spare parts

1
1.1 screw cover
2
3
4
5
6
7
8
9
9.1 pull knob
9.2 pull rod
10
11
XXX = Colors
000 chrome plated
090 chrome/gold plated
880 satin chrome
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
lever head
flange
nut
cartridge cpl.
service set
seals (5)
mixer ball
aerator cpl. (10)
pull rod cpl.
fixation cpl.
connection hose
15091XXX
94063XXX
94130XXX
94106000
14095000
13952000
13962000
13964000
13085000
92620XXX
94066XXX
94067000
13961000
94071XXX
6