Procedure example
While the operation stops, change the setup.
(Be sure to stop the operation of the unit.)
Procedure
Push simultaneously
shown below. Check the displayed CODE No. is [10].
• When the CODE No. is other than [10], push
erase the display and repeat procedure from the first step.
1
(After pushing
is not accepted for approx. 1 minute.)
(For a group control, No. of the firstly displayed indoor unit
becomes the header unit.)
Every pushing
Select the indoor unit of which setup is changed.
2
In this time, the position of the indoor unit of which setup is changed can be confirmed because fan of the
selected indoor unit operate.
Using temp. setup
3
-1
CODE No. [12]. (CODE No. [12]: Line address)
Using timer time
3
-2
from [3] to [2].
SET
Push
button.
3
-3
In this time, the setup finishes when the display changes from
flashing to lighting.
Using temp. setup
4
-1
CODE No. [13]. (CODE No. [13]: Indoor address)
Using timer time
4
-2
from [3] to [2].
SET
Push
button.
4
-3
In this time, the setup finishes when the display changes from
flashing to lighting.
Using temp. setup
5
-1
CODE No. [14]. (CODE No. [14]: Group address)
Using timer time
5
-2
[0001] to [0002].
(Setup data [Header unit: 0001] [Follower unit: 0002])
SET
Push
button.
5
-3
In this time, the setup finishes when the display changes from
flashing to lighting.
Manual address setup procedure
3
4
-2,
SET
CL
TEST
+
+
buttons for 4 seconds or more. After a while, the display part flashes as
TEST
button, operation of the remote controller
UNIT
LOUVER
button, the indoor unit No. in the group control is displayed in order.
/
buttons, specify
/
buttons, change the line address
/
buttons, specify
/
buttons, change the indoor address
/
buttons, specify
/
buttons, change the setup data from
TEMP.
5
-2,
-2
TIMER SET
7
TIME
FILTER
RESET
TEST
SET
CL
1
Description
TEST
button to
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
26
7
ON / OFF
3
4
-1,
FAN
MODE
2
6
SAVE
VENT
,
SWING/FIX
UNIT LOUVER
3
4
-3,
∗
(
Display changes according
to the model No. of indoor unit.)
5
6
-1,
-1,
5
-3,
-3