Rear Panel - Panasonic AW-RP400E Bedienungsanleitung

Pan/Tilt Head Controller AW-RP400
Parts and their function

$ Rear panel

M EXT CONT IN/OUT connectors
When an additional AW-RP400 controller is to be
provided, connect these connectors on the two
AW-RP400 controllers using a 10BASE-T (equivalent to
UTP category 5) straight cable.
Master
controller
AW-RP400
EXT CONT
IN
EXT CONT
10BASE-T straight cable
OUT
N CAMERA CONTROL IN FROM RCB [P1] to [P5]
connectors
Connect the WV-CB700A remote control boxes to these
connectors.
The cameras installed on the pan/tilt heads
corresponding to the ports where the WV-CB700A boxes
have been connected can then be controlled.
When even one WV-CB700A box is connected, the
cameras cannot be controlled from the AW-CB400
remote operation panel even if the AW-CB400 is
connected.
M N
R
Slave
controller
AW-RP400
EXT CONT
IN
10BASE-T
EXT CONT
OUT
O P
S T
O TALLY/INCOM connector
Connect this to the TALLY/INCOM connector on the
video switcher or other unit.
When the TALLY input connector is set to the GND level,
the TALLY lamp on the controller or pan/tilt head lights.
Do not apply a voltage in excess of 5V to this connector.
87654321
?>=<;:9
Pin layout as seen from the
back panel of AW-RP400
Use the accessory plug (D-SUB 15-pin) to connect the
tally/INCOM signals to the system.
Connect a 4-wire INCOM system to the INCOM
connector.
When an additional controller has been provided or when
the AW-CB400 remote operation panel has been
connected, the tally or INCOM function of all the units will
take effect if tally or INCOM signals are connected to one
of the units.
23 (E)
Q
U
Pin No. Signal name
1 TALLY1
9 TALLY2
2 TALLY3
10 TALLY4
3 TALLY5
11 TALLY GND
4 – – –
12 – – –
5 – – –
13 – – –
6 MIC+
14 MIC–
7 INCOM GND
15 SP–
8 SP+