Carrier HDB Gebrauchsanweisung Seite 8

HDB – IR
Use of the remote control
Selecting the fan speed
(button E)
The fan speed can be selected by pressing button
Indicated symbol
Low speed
(for night operation)
Medium speed
High speed
(at start-up, to reach temperature)
automatic (fan speed will automatically switch to the value
required for optimum comfort).
ON timer procedure
1.
ON TIMER button
Press this button, even if the remote control
is Off.
The relevant icon and time figure will startto
flash.
If 10 seconds have elapsed and no button
is pressed, the remote control turns Off
(if it was already Off when button
AM
pressed) or timer function automatically
deactivates.
2.
HOUR/MINUTE buttons
(buttons
If the unit is ON, the only possible selection
is the start-up time. The unit will operate with
the selections shown on the display.
3.
HOUR/MINUTE buttons
(buttons
If the unit is OFF: to select the start-up time,
use the temperature control buttons (buttons
and
First select the hours and, after have
confirmed these by pressing button
select the minutes using either button
or
To definitively set the time, press button
again.
4.
Operating mode
Choose the unit operating mode.
The icons will flash.
To select the mode, use the button
Once the mode has been decided, press
button
The icon of the selected mode will stop
flashing.
5.
Desired temperature
To select the desired temperature, (the
value is flashing, use either button
Push button
Numbers will stop flashing.
6.
Fan speed
Choose the fan speed, using button
When the selection has been completed,
press button
The icon will stop flashing.
GB - 6
.
(button I)
and )
and )
).
.
.
, to confirm the selection.
for confirmation.
About the ON timer
OFF timer procedure
was
AM
Personalisation
,
If you want memorize a personalised operating mode, recallable at
any time, proceed as follows:
1. With the remote control ON or Off, press button
hold it pressed for more than 5 seconds. On the display, the
personalisation icon
2. Press button
.
3. Press either button
4. Using button
5. Using button
6. When all options have been entered, press button
or .
memorise them.
at this point, all selected and memorised functions can be activated
through button , whatever the unit operating mode.
Once the personalised mode has been entered, press one of the
.
buttons , , ,
If you want to change one or more memorised parametres, begin
again from point 1.
7.
Louvre positioning
Now this icon is flashing.
Use button , to select desired position.
Press button for confirmation.
Now all icons are fixed on display.
If you want to cancel selections up to here
inserted, push button ; if you want to
cancel all options once timer has been set,
push button and then
• When the "ON Timer" function is active, the
units controls air temperature in the room
one hour before the pre-set start time.
• The unit start can be brought forward based
on the programmed start time, by 0 to 40
minutes, depending on the temperature
difference between the room and the
selected temperature.
1.
OFF TIMER button
Press button .
The Off timer icon and numbers for time
selection are flashing.
This function can be set even if the remote
control is Off.
2.
HOUR/MINUTE selection buttons
(buttons and )
To set the clock time, press either button
or .
To move from hour to minute, press
button .
Press button again to confirm.
and (buttons G and F)
will start flashing.
, to select the operating mode.
or to select the desired temperature.
select the fan speed.
select the louvre operation.
or to exit.
.
(button L)
and
to