bloom Fresco contemporary Anleitung Seite 17

eng
(b-b5) Seat pad & safety harness assembly
– (#05, #06) Put shoulder straps through the
seat pad slits at the lower height setting.
– Put waist straps through the seat pad slits.
– Place seat pad onto the seat unit.
– Behind the seat pad, slide the buckle on the
end of the shoulder straps into the buckle
slots located on the inner face of seat unit.
Check the straps are secured by pulling on
the straps.
– (#09) Behind the seat pad, pull open storage
compartment door located on the inner face
of seat unit. Slide the buckle on the end of
the waist straps into the buckle slots on either
side of the storage compartment. Check the
straps are secured by pulling on the straps.
– (#12, #13) From storage compartment, take
out the two 'U' shaped clips and the crotch
strap cover. Close the compartment door.
– Snap the 'U' shaped clips on either side of the
seat unit; you will hear an audible click.
– Place buckle on the end of the crotch strap
under the crotch strap cover, then slide the
crotch strap cover into the seat unit.
– Adjust the length of the shoulder straps using
the buckle until it fits firmly around your child.
WARNING: Always use the safety harness.
To remove the seat pad & safety harness for
cleaning, follow the instructions given in the care
& maintenance section of this instruction guide.
(b6-b7) Using and adjusting the safety harness
Locking the safety harness:
4
Lock the harness by pushing the tongues on
the ends of the waist straps, connected with the
ends of the shoulder straps, into the buckle on
the crotch strap.
The harness will automatically lock when the
tongues have been fully pushed in. You will hear
an audible click.
Unlocking the safety harness:
Squeeze the ends of the tongues together and
then slide them out of the buckle. Your child can
now be removed form the highchair.
NOTE: Every time you place your child in the
baby chair or whenever you alter the position
of the seat always check that the harness is
correctly fitted and adjusted using the shoulder
and waist strap buckles. Tighten the harness
until it fits snugly around your child.
(b8) Seat unit height
Ensure the seat unit is set at the lowest height
setting.
(b9) Seat unit recline
Adjust the seat unit to lie-back position by
pressing the handle on the rear of the seat unit,
then reline the seat to the lowest position, then
release the handle. You will hear an audible
click. Check the seat unit is locked in position
by moving it. Ensure the seat unit is reclined to
the lowest lie-back position for children from
newborn to approximately 6 months of age, until
child can sit up unaided.