bloom Fresco contemporary Anleitung Seite 16

(a6) To disengage
Squeeze the childproof plastic tab sideways and
hold, whilst pulling the metal lever outwards
fully. Check the device is disengaged by turning
the seat unit.
(a7) Swivel adjustment
To rotate the seat unit, disengage the swivel/
height resister, then turn the seat unit sideways
to desired position. Engage the swivel/height
resister.
NOTE: Engage the swivel/height resister whilst
your child is in the seat.
(a7) Height adjustment
Disengage the swivel/height resister. Lift both
A & B trigger simultaneously, whilst pushing
downwards or pulling upwards to desired
height, then release the triggers. Engage the
swivel/height resister.
WARNING: Do not adjust your highchair whilst
your child is in the seat.
IMPORTANT!
Ensure the seat unit is firmly inserted onto the
swivel shaft before use. Check the seat unit
is assembled properly by trying the height
adjustment function, following the instructions
in this user guide. If the height adjustment fails
to work, this means the seat unit is not properly
assembled, please re-try and press seat unit
downwards on the swivel shaft firmly in order
to properly engage the height adjustment
mechanisms.
(a8-a9) Lift & glide – easy glide wheels
To move the baby chair across floor, first rotate
the seat unit so it is front facing. Tilt the baby
chair forward by lifting on the handle located
on the rear of the seat unit, and then glide the
highchair across floor using the castor wheels,
which are located under the front end of the
base.
WARNING: Continue to assemble the baby
chair according to the configuration suitable
for your child. Follow the corresponding
instructions carefully.
WARNING: A CHILD'S SAFETY IS YOUR
RESPONSIBILITY.
Cradle Mode
– suitable for 0 – 6 months
(refer to section b of Illustrations)
WARNINGS:
• Not recommended for children who can sit
up by themselves (6 months approximately).
• Never leave the child unattended when the
baby chair is in cradle mode.
• It is dangerous to put this cradle on an
elevated surface.
• Keep the cradle away from open fire,
heaters and other sources of strong heat.
• Do not use the cradle unless all components
are correctly fitted and adjusted.
• Make sure harness is correctly fitted before
use.
eng