Velleman K6713 Gebrauchsanweisung Seite 23

- Switch outputs 1 and 3 on and preserve this state in memory 1
(MEM1). Pay attention to that ALL FOUR receivers have
preserved this state (flashing of both the relay and the LED).
While preserving the memories you must possibly point to the
different receivers.
- Set all outputs back off (CLEAR key)
- Switch outputs 2 and 4 on and preserve this state as well, this
time in memory 2 (MEM2). Also now pay attention to that ALL
FOUR receivers have preserved this state.
When you now press CALL1, only receivers 1 and 3 will react,
while when you press CALL2, only receivers 2 and 4 will react.
The whole consisting of two modules can be fitted in a standard
adapter housing, if required:
First make the holes in the cover as shown in figure 6.0. Connect
the mains plug to the MAINS connections. Mount the modules into
the housing as shown in figure 7.0 After having fitted the cover,
check that the LED, the IR diode and the push button are in the
right positions.
TIP
Should the receiver not work, which could be caused by a bad
'start-up' of the processor when it was powered on, then remove
the mains voltage for a couple of minutes and try again.
The sensitivity of the receiver can be increased by decreasing the
value of R4 and/or increasing the value of R2. However, this will
make the receiver also more sensitive to interferences such as
sun light.
H6713-ED1-23