Defrosting The Cooling Device - Dometic HIPRO Serie Montage- Und Bedienungsanleitung

Using the refrigerator
➤ Press the yellow button (3) to set the cooling temperature to 3 °C or 7 °C.
✓ The LEDs of the interior light (5) flash three times or seven times, respectively, to
display the preset temperature (fig. i, page 12).
➤ Press the blue button (4) to set the cooling temperature to 5 °C or 12 °C.
✓ The LEDs of the interior light (5) flash five times or twelve times, respectively, to
display the preset temperature (fig. i, page 12).
I
NOTE
8
The red LED illuminates as soon as a signal has been sent out. Check the
batteries if the LED does not illuminate.
8.6 Using the door opening monitor
The door opening monitor (optional) displays via an LED (fig. 1 4,page 2) whether
the refrigerator door has been opened.
If the door opening monitor LED illuminates:
➤ Open the refrigerator.
➤ If necessary, refill the refrigerator.
➤ Reset the door opening monitor with the remote control (optional). To do this,
press the red button once (fig. i 1, page 12).
➤ Close the refrigerator.
8.7

Defrosting the cooling device

The refrigerator is equipped with an automatic defrosting function.
The defrosting phase takes place every 22 hours for a duration of 2 hours.
I
NOTE
The first defrosting phase starts 39 hours after the refrigerator has been
switched on. Start-up during the day ensures that the defrosting phases
occur during nighttime hours.
8.8 Switching off and storing the refrigerator
If you do not intend to use the refrigerator for a long time, proceed as follows:
➤ Pull the power plug out of the socket.
➤ Clean the refrigerator (see chapter "Cleaning and care" on page 25).
24
HiPro
EN