Cleaning And Care; Troubleshooting - Dometic HIPRO Serie Montage- Und Bedienungsanleitung

HiPro
9

Cleaning and care

A
NOTICE! Risk of damage!
•
Clean the refrigerator regularly and as soon as it becomes dirty.
•
Do not use any soap or strong, grainy or alkaline cleaning agents.
•
Do not use any hard implements for cleaning.
•
Do not use hard or pointed tools to speed up the defrosting process.
•
Make sure that no water drips into the seals. This can damage the
electronics.
•
Do not allow grease or oil to come into contact with the door seal.
•
Do not re-lubricate the cylinder locks (optional). The cylinder locks
have been permanently lubricated at the factory.
➤ Disconnect the device from the mains supply prior to cleaning and maintaining it.
➤ Clean the refrigerator with a soft cloth and lukewarm water. Use a mild cleanser.
➤ Rinse the refrigerator after cleaning with clear water.
➤ Finally, wipe the refrigerator dry with a cloth.
➤ Use a brush or soft cloth to remove dust from the absorber unit on a yearly basis.
10

Troubleshooting

Fault
No cooling, absorber
unit cold
EN
Possible cause
Power plug not plugged in
No voltage in socket
Electronics or sensors defective
Heating cartridge defective
Defrosting phase active (see chapter
"Defrosting the cooling device" on
page 24)
Cleaning and care
Solution
Insert power plug in
socket
Check household fuse
Authorized service: Install
new electronics or sensor
Authorized service:
Install new heating car-
tridge
No action required
25