Herunterladen Inhalt Inhalt Diese Seite drucken

Ferm FLB-2100 Gebrauchsanweisung Seite 6

Inhaltsverzeichnis

Werbung

GB
Do not use in rain.
D
Wear ear and eye protection.
NL
Sound power level
F
Faulty and/or discarded electrical or electronic apparatus have to be collected at
the appropriate recycling locations.
E
Additional safety warnings for blower/vacs
P
Dispose of plastic bags safely - they are a suffocation hazard for young children.
Keep the area you are working in clean and tidy.
Do not use power tools in the rain or wet environments.
I
We strongly recommend the use of an RCD (Residual Current Device) of not more than 30
mA, at the plug socket when using this appliance.
Do not use power tools where there is a risk of fire or explosion - i.e. near flammable liquids
S
or gases.
Do not allow people especially children or pets into the area where you are working.
Do not let children or other people touch power tools.
SF
Store in a dry place well out of reach of children.
Always use safety glasses. We also recommend the use of ear protectors.
N
Wear the right clothes (long trousers) - not loose fitting or jewellery and ensure garments
cannot come into contact with moving parts.
Wear non-slip shoes. Do not wear sandals or open-toed shoes.
DK
If you have long hair, tie it back safely to avoid tangling it in moving parts.
Before using any power tool, check first for damaged parts and if found do not use them
before the part or parts have been replaced with new ones.
Do not use power tools when you are tired or have been drinking alcohol.
Do not overreach while working - you may lose your balance.
You must switch off your tool at the tool's on/off switch after use.
Only use this appliance for its intended purpose - blowing or sucking up leaves.
Do not point the blower at people or animals.
Do not blow debris in the direction of people or animals.
Operate the appliance only in daylight or in a good artificial light.
Do not place your hand inside the blower tube or bag until the blower has been switched off
and the plug removed from the power supply.
Only use extension leads that are suitable for outdoor use. The cord must be kept away
from excessive heat, oil, solvents and sharp edges.
Do not use the vacuum to remove liquids of any kind.
Do not vacuum up hot or burning materials i.e. fire embers, matches, recently extinguished
cigarette stubs.
Never operate the vacuum without the bag securely fitted.
Periodically check that all bolts and screws are tight.
6
Tilslut den brune leder (Strømførende) til klemmen, mærket L eller farvet rød eller brun.
Ved brug af forlængerledninger
Brug udelukkende godkendte forlæn gerledninger, der er beregnede til maskinens effekt.
Lederne skal have et gennemsnit på mindst 1.5 mm
tromle, rulles ledningen helt af.
3. MONTAGE
Montage
Fig. 1
Sæt de to dele (7 og 8) til blæse/sugerøret sammen (klikkes sammen) og fastgør dem til selve
sugeren som vist.
Fig. 3
Lås dem fast med låsemekanismerne på oversiden og undersiden af selve sugeren.
Sådan sættes posen på
Fig. 1
Posen skal altid sættes på, når der suges!)
Den åbne ende af posen skal sættes over kanten (11) på indgangsrøret og kan fastgøres ved
hjælp af snoren.
4. BRUG
Brug
Fig. 1
Sæt stikket til maskinen i en stikkontakt (eller sæt det i en forlængerledning), og når man er klar
og i balance, trykkes på afbryderen (5), hvorefter maskinen starter. Tryk igen for at slukke.
Bemærk: Vi anbefaler, at der bruges en solid forlængerledning til udendørs brug.
Indstil selen, så løvsugeren kan bruges i opretstående stilling, og den skal holdes, så den
støtter på hjulene, når den bruges (kun model 2400 Watt). Så trykker selen ikke så meget på
skuldrene og ryggen.
Brug bevægelser frem og tilbage, ikke fra side til side.
Omskiftning mellem blæsning og sugning
Fig. 2
Når der skal skiftes mellem blæsning og sugning, skal valggrebet blot sættes i den ønskede
position. Drej den med uret for at blæse og mod uret for at suge (husk at sætte posen på, hvis der
skal suges).
Ferm
Ferm
2
. Hvis forlængerledningen sidder på en
UK
D
NL
F
E
P
I
S
SF
N
DK
79

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Flb-2400

Inhaltsverzeichnis