Danfoss FH-CWP Gebrauchsanweisung Seite 16

Displaying the Floor Temperature
The function allows you to check the internal tem-
perature of the floor. Works only with floor sensor.
Turn ON the thermostat by pressing
• Press M Fig. 1 shortly and
display.
• The actual floor temperature is shown in the
display.
Setting maximum floor temperature
Turn OFF the thermostat by pressing
• Press M Fig. 1 for 5 seconds until the display
shows .
• Release M Fig.1, and the display shows
.
• Press or
floor temperature limit.
• Wait 5 seconds for the thermostat to exit SET
mode and power off.
16
VI.CU.C2.2D
Instruction FH-CWP Thermostat
Fig. 1 to set the desired maximum
Produced by Danfoss Floor Heating Hydronics 05.2011
Fig. 1.
will flash in the
Fig. 1