Screw; Front Post; Washer - Klarfit 10022301 Handbuch

How to pull tension cable from front post
1
Pull Tension Cable
from front post.
Step 6:
Fix the Handlebar (35) to the Front Post (26) and tighten with 1xCover of handlebar(20), 1x Washer
(19), 1x Spacer (18) and 1 xT Knob(17). Then connect the Middle pulse wire(32A) with Upper pulse
wire(29A).
13
2
Attach the cable to the rear of the Ten-
sion Knob by inserting the end of the
tension wire into the clasp on the end
of the lower tension cable then pull
upwards and insert the end of the ou-
ter cable into the top of the U shaped
bracket. Please note at this stage you
may need to pull the handlebar post
upwards with some force to increase
the length of the cable.
3 4
Place the Tension knob housing into
the front post fix in place by using the

screw.

5