Vortice CALDOPRO PLUS series Betriebsanleitung Seite 11

ENGLISH
2 2
60 cm
• Before disconnecting the appliance from the power
• Do not make modifications of any kind to this
• Pay special attention when using it in rooms that are
• Regularly inspect the appliance for visible defects. If
• Should the appliance be dropped or suffer a heavy
• If the appliance does not function correctly or
60 cm
• Never position the appliance directly under a power
• The electrical safety of this appliance is only
• Check that the electrical power supply/socket
• If the power socket is of a different type to the plug
• Do not pull on the power cable, do not place it near
• Do not cover the power cable, to avoid any risk of
• A limited increase in temperature in the power cable
• Never place the power cable in front of the heating
• Always keep the appliance in an upright position.
• When the appliance is not being used, switch it off
• Before cleaning the appliance in any way, switch it off
• Do not immerse the appliance in water.
Caution:
this symbol indicates that care must
be taken to avoid damaging the appliance
supply, leave it running for a few minutes in
Ventilation mode.
appliance.
not manned.
the appliance does not function correctly, do not use
it and contact Vortice* immediately.
blow, have it checked immediately by Vortice*.
develops a fault, turn it off, disconnect the plug from
the power supply and contact Vortice* immediately.
Ensure that only genuine original Vortice spares are
used for any repairs.
socket.
guaranteed when it is correctly installed and earthed
according to the latest issue of the I.E.E.Wiring
Regulations. If in doubt, have a qualified electrician
perform a thorough check.
provides the maximum electrical power required by
the appliance.
fitted on the appliance, ask a qualified technician to
replace the plug with one of the right type. Do your
best to avoid the use of adapters, multiple sockets
and/or extension leads; if necessary, first make sure
that they comply with current safety regulations and
check that the maximum allowed power is compatible
with the values on the appliance's rating plate. Any
extension leads must be as short as possible, to
prevent them from overheating and triggering the
thermal cut-out devices.
heat sources, and always uncoil it completely to
prevent dangerous overheating. If the cable or the
power plug are damaged, take the appliance to an
authorised Vortice* service centre for replacement.
overheating or damage; at the same time, make sure
it is placed so that it does not create an obstacle.
and plug during use of the appliance is to be
considered normal; however, if the phenomenon
increases to the point that they become too hot to
touch or start to
immediately.
elements.
and disconnect the plug from the power supply.
and then disconnect the plug from the power supply.
deform, contact Vortice*
11