Clean The Machine; Store The Machine; Troubleshooting; Technical Data - GreenWorks G40TL Bedienungshandbuch

EN
5.1

CLEAN THE MACHINE

Keep the machine and the motor free of leaves,
branches or excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
6

STORE THE MACHINE

• Clean the machine before storage.
• Make sure that the motor is not hot when you store
the machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
7

TROUBLESHOOTING

Problem
The motor shuts
down whilst
working.
The machine
smokes during
operation.
WARNING
Possible cause Solution
Make sure that
The battery pack you tighlty instal-
is not installed led the battery
tightly. pack in the ma-
chine.
The battery pack Charge the bat-
is out of power. tery pack.
The machine Do not use the
has damage. machine and
speak to service
center.
1. Immediately
stop the ma-
chine.
The machine 2. Remove the
has damage. battery.
3. Speak to
service cen-
ter.
English
Problem
Motor runs but
tines do not
move.
8

TECHNICAL DATA

Voltage
No load speed
Cultivating path
Protection degree
Weight (without battery pack)
Measuered sound pressure level
Measuered sound power level
Guaranteed sound power level
Vibration
Uncertainty
9

WARRANTY

(The full warranty terms and conditions can be found on
Greenworks webpage)
The Greenworks warranty is 3 years on the product,
and 2 years on batteries (consumer/private usage) from
the date of purchase. This warranty covers
manufacturing faults. A faulty product under warranty
might be either repaired or replaced. A unit that has
been misused or used in other ways then described in
the owner's manual might be rejected for warranty.
Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not
affected by any additional warranty offered by a dealer
or retailer.
A faulty product must be returned to the point of
purchase in order to claim for warranty, together with
the proof of purchase (receipt).
6
Possible cause Solution
Do not use the
The machine machine and
has damage. speak to service
center.
Remove battery
The tines are then clear block-
blocked. age from the
tines.
Gear train fail- Speak to service
ure. center.
40V
200 (±10%)
RPM
8'' (20cm)
IPX1
12 kg
L :80dB(A)
PA
K :3dB(A)
PA
L :91 dB(A)
WA
L 93 dB(A)
:
WA.d
2.36 m/s
k=1.5 m/s
2
2